Skip to main content
Portfolio News Contact Us Chat

Roof Flashing Repair.

We repair roof flashings in Kelowna and across the Okanagan: around chimneys, skylights, pipes and vents, and wherever a roof meets a wall. We’re an IKO Certified Installer. Free estimates, and an honest answer about whether it is worth repairing.

Chimneys, skylights, pipes and walls.

Flashing is what turns the water away wherever the roof is interrupted: at a chimney, a skylight, a pipe or a wall. This is where most leaks start, not out in the open field.

We find where the water is actually getting in, fix that, and tell you honestly what the rest of the roof has left.

Emergencies go to the front of our line, and we stop the water first, then fix the cause.

Emergency Roof Repair

Black sheet-metal cricket on the uphill side of a brick chimney on a shingle roof
01 / 07Asphalt Shingle • Chimney Cricket

Chimneys.

Where a roof meets a chimney is one of the most common places for a leak. Most chimney repairs are at the flashing set into the brick, the more exposed part, which can pull away from it. Behind a wide chimney, a cricket turns the water aside so it does not pool against the brick.

  • CommonLeak Spot
Skylight with black flashing on a shingle roof in low sun, mountains behind
02 / 07Asphalt Shingle • Skylight Flashing

Skylights.

When a skylight leaks, it is usually the perimeter flashing rather than the glass. Sometimes the unit is fine and the flashing was never right. A skylight bedded in caulk instead of flashed is the one we get called out to fix.

  • FlashingNot the Glass
A perished rubber pipe boot on a shingle roof, split open around the stack
03 / 07Asphalt Shingle • Split Pipe Boot

Pipe Boots.

Plumbing stacks, vents and anything else that punches through the roof. A pipe boot gives out years before the shingles around it, and a split one is open right where the water runs. Cracked pipe boots and lifted flashings get resealed or replaced outright.

  • MostLeaks Start Here
An open black metal valley with a centre rib, running down between two shingle slopes
04 / 07Asphalt Shingle • Open Metal Valley

Valleys.

An open valley is lined with metal, and it carries the drainage of two slopes into one line. That makes it a critical part of the roof.

  • Two SlopesInto One Line
Black step flashing woven in with the shingles where a roof runs up a sided wall
05 / 07Asphalt Shingle • Step Flashing

Sidewalls.

Where a pitched roof runs up against a wall or a dormer, the flashing is stepped in with the shingles. It turns the water away from the wall and back onto the roof.

  • SteppedIn With the Shingles
Metal caps along the stucco parapet walls around a grey flat roof, a shingle roof and tall evergreens behind
06 / 07Flat Roof • Parapet Caps

Parapets.

On a flat roof, the flashing runs up the parapet wall. Where it has come loose, or the sealant above it has shrunk and cracked, water runs straight in behind the roofing.

  • EveryType of Flat Roof
Black metal cap along the top of a stucco wall, beside a shingle roof and a glass-railed deck
07 / 07Stucco Wall • Metal Wall Cap

Wall Caps.

The top of a wall is open to the rain. A metal cap covers it and throws the water off both sides, so it does not soak down into the wall below.

  • Both SidesShed the Water

What else we fix.

Almost everything we get called out for is on this list, and most of it is one detail rather than a whole roof.

01

Lifted & Loose Flashing

Flashing that has lifted above the shingles or come loose stops turning the water away. On a roof with years left, it is worth repairing.

02

Rust & Holes

Rust, corrosion, or holes torn by the wind. Once the metal has gone through, the flashing is replaced.

03

Edge Metal

The metal along the roof’s edges lets the water drip clear of the house. Torn or lifted edge metal gets dealt with before wind or water gets in under it.

04

Kickouts

Where a wall comes down to the roof’s edge, a kickout at the bottom turns the water into the gutter instead of down the wall.

05

Custom Flashing

When a detail needs a flashing that does not exist as a stock profile, we draw it and have it formed by the metal suppliers we work with, rather than forcing the roof to accept something that nearly fits.

New black torch-on flat roof with white edge metal and a re-flashed brick chimney, the hillside behind
Residential • New Torch-On • Chimney Re-Flashed

Repair or Re-Roof?

A lifted flashing or a failed pipe boot is worth repairing on a roof with years left. When the roof around it is failing everywhere, the flashing is renewed with a new roof, and a repair on its own is money spent twice. We will tell you which one you have.

  • RepairOne Failed Detail
  • Re-RoofFailing Everywhere

Flashing repair questions.

Yes. We repair roof flashings in Kelowna and across the Okanagan: around chimneys, skylights, pipes and vents, in valleys, along roof edges and wherever a roof meets a wall.
It is the material, usually metal, that turns water away wherever the roof is interrupted: at a chimney, a skylight, a vent or a wall. It is typically laid in under the shingles, and it sends the water back out onto them instead of into the roof.
The usual signs are flashing that has lifted or come loose, rust or holes in the metal, loose or missing nails, and sealant that has dried out. A water stain near a chimney, a skylight or a wall can point to the flashing too, though stains also come from ventilation or condensation, so we find the cause first.
Not on its own. Sealant has its place, where the instructions put it, but caulk is not flashing and cannot stand in for it. We fix the flashing itself.
Yes, on a roof with years left. A lifted flashing or a failed pipe boot is one failed detail, and a good repair can save the roof. When the roof around it is failing everywhere, the flashing is renewed with a new roof, and a repair on its own is money spent twice. We will tell you which one you have.
We do not quote a roof we have not seen. The visit, the look and the quote are free. In towns further out, like Salmon Arm, Revelstoke, Osoyoos, Oliver and Merritt, a travel charge may apply to the visit. If tracing a leak means opening up the roof, that is paid work, and we tell you before we start.
Call 250-258-8600. We stop the water first, then fix the cause. Outside office hours, leave a message and we’ll get back to you as soon as we can.
Yes. Parapets, curbs, vents and anything else that comes through the roof. We repair every type of flat roof: torch-on, TPO, EPDM, PVC and tar and gravel. See commercial flat roof repair.
Yes. We repair all types of pitched roofs, including metal, tile and cedar shake, and every type of flat roof. See roof repairs.
Yes. When a detail needs a flashing that does not exist as a stock profile, we draw it and have it formed by the metal suppliers we work with, rather than forcing the roof to accept something that nearly fits.
We stand behind the work we did. Whether a repair carries a warranty, and for how long, depends on the roof and the job, and it is set out on your quote. If water later finds another way in, through a second entry point or an ageing roof, that is a new problem, not a fault in the repair.
It can, if the work is done with incompatible materials or by someone not approved to touch that system. Tell us what warranty is on the roof before we start, and we will tell you whether we can work within it.
We work the full valley, from Armstrong and Vernon down to Penticton: Kelowna, West Kelowna, Lake Country, Coldstream, Peachland and Summerland. We also take jobs further out, including Enderby, Lumby, Salmon Arm, Sicamous, Chase, Revelstoke, Oliver, Osoyoos, Big White and Merritt. A travel charge may apply to any site visit there, estimates and inspections included. Depending on the job, we may waive it, or take it off the price of the project once it’s fully approved.

Need a roof looked at?

Tell us about the roof and what you are seeing, and we’ll come and take a look. Free estimates.

Free estimates • Roof flashing repairs • Kelowna & the Okanagan